Kamishibai Story Theatre

Kamishibai: a paper theatre for telling picture stories. The story cards stand in a finger-jointed frame and slide out through a slot in the side, one picture…

Settings

Switch to Batch to make the same design for a list of names.

Units

Theatre

Card width
Card width
Card height
Card height
Stack
Inside depth, for the stack of cards
Title
Title on the sample card
Top door
Height of the top door, as part of the frame height

Assembled view

Open
How far the doors are open, 0 to 1

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Kamishibai Story Theatre

About this design

Laser cut & 3D print

Kamishibai: a paper theatre for telling picture stories. The story cards stand in a finger-jointed frame and slide out through a slot in the side, one picture at a time, while you read the words printed on the back of the card in front through the back window. Two side doors and a top door open like curtains for the show. Use 6 mm plywood or thicker so the hinge screws have wood to bite. Assembly: glue the frame. Hinge each side door on the front edge of its side and the top door on the top front edge with small brass hinges, using screws no longer than the plywood is thick.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs