
Four in a Row
Four in a row: drop your tokens into the columns and be first to line up four, across, up or diagonally. The board is two face plates held apart by the column…
Settings
Board
Assembled view
Material
3D Preview
Photos

About this design
Laser cut & 3D print
Four in a row: drop your tokens into the columns and be first to line up four, across, up or diagonally. The board is two face plates held apart by the column separators, whose tabs pass through both plates and are glued, so the board stays square and flat. It slides into the two stands, and pulling the release bar out at the bottom lets all the tokens fall out to start again. One player's tokens are walnut, the other's plywood. Assembly: glue the separators' tabs into one face plate, lay the release bar along the bottom without glue, and glue the other plate on, checking the bar still slides.
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
Set the material thickness to the sheet you cut. The slots and tabs follow it.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









