
Six-slot stencil for a repeatable projector focus check
Cut six slots (112×76 mm plate, 2.5 mm slots, 3.5 mm webs). Import the SVG at 100%, measure the cut outline and test on scrap. Stencil the bars onto paper…
Settings
Stencil
3D Preview
Photos

About this design
Laser cut & 3D print
Cut six slots (112×76 mm plate, 2.5 mm slots, 3.5 mm webs). Import the SVG at 100%, measure the cut outline and test on scrap. Stencil the bars onto paper, scan square-on and check that all six lines remain distinct. Put equal tiles at the centre and four corners of one slide. Export and check the source file first. Project it twice. If one corner blurs first, adjust position and focus. If all blur, enlarge the tiles and check scaling. Model checked; no physical test. X500 focus steps
Personal useNo commercial use
Personal use only What does this mean?
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
No. The licence covers personal use only.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.





